thats the shimming i use on the stock tower to make getting to the inner ball studs easier then i compensate on the upper mount of the shock with spacers. works well
Are you using the3x7x2mm shims
Yes, sorry for the long delay. Thanks, Jared Tebo
Hi Jared,
Hi from France 🙂
Im newb in rc (a real addiction) and i search to understand
Can u confirm if i have understand correctly the anti skat settings
With stock rear RB6 Shock Tower :
0 degree = thick under bulkhead / none under susblock
1 degree = thin under bulkhead / thin under susblock
2 degree = none under bulkhead / thick under susblock
With JTP rear RB6 Shock Tower :
1 degree = thick under bulkhead / none under susblock
2 degree = thin under bulkhead / thin under susblock
3 degree = none under bulkhead / thick under susblock
i’m right ?
Thx a lot
My JTP tower doesn’t change the anti squat setting. The flatter the rear arm, the less anti squat. Thin thin is 2 degree. Thick/none is 3 degree. None/thick is 1 degree.
Jared Tebo
Hi, Jared
I get a little confused about the anti squat angle of RB6. Most times, I see your setup that you won’t put a shim under the RF sus blocker, just adjust the RR sus block. So if I want 2 degree of anti squat, I put 0.5mm shim under the RR sus blocker and 0.5mm under the rear bulkhead, right? But if I want 3 degree of anti squat, I think I should remove the 0.5mm shim under the RR sus blocker and change the bulkhead spacer into the 1mm one. Right?
thats the shimming i use on the stock tower to make getting to the inner ball studs easier then i compensate on the upper mount of the shock with spacers. works well
Are you using the3x7x2mm shims
Yes, sorry for the long delay. Thanks, Jared Tebo
Hi Jared,
Hi from France 🙂
Im newb in rc (a real addiction) and i search to understand
Can u confirm if i have understand correctly the anti skat settings
With stock rear RB6 Shock Tower :
0 degree = thick under bulkhead / none under susblock
1 degree = thin under bulkhead / thin under susblock
2 degree = none under bulkhead / thick under susblock
With JTP rear RB6 Shock Tower :
1 degree = thick under bulkhead / none under susblock
2 degree = thin under bulkhead / thin under susblock
3 degree = none under bulkhead / thick under susblock
i’m right ?
Thx a lot
My JTP tower doesn’t change the anti squat setting. The flatter the rear arm, the less anti squat. Thin thin is 2 degree. Thick/none is 3 degree. None/thick is 1 degree.
Jared Tebo
Hi, Jared
I get a little confused about the anti squat angle of RB6. Most times, I see your setup that you won’t put a shim under the RF sus blocker, just adjust the RR sus block. So if I want 2 degree of anti squat, I put 0.5mm shim under the RR sus blocker and 0.5mm under the rear bulkhead, right? But if I want 3 degree of anti squat, I think I should remove the 0.5mm shim under the RR sus blocker and change the bulkhead spacer into the 1mm one. Right?
yes, you are correct, sorry for the long delay.