Thanks for sharing. Why did you go back to the original chassis vs the new prototype?
RB6 Castor Block Position In(wide Std) is that referring to the hole in making the tire track width wide?
Out(Narrow) hole outside making the tire track width narrow?
Also spacer on front axle (kit show 2mm spacer in and out), typically your setup sheets show 2mm outside only??
Yes, you are correct with the track width. The front axle spacing, I always just run the standard kit spacing.
Jared what was the idea behind putting the front bulkhead under the chassis?
Are you just talking about the design of the RB6? I’m not sure, I did not design it and I’m not an engineer. Sorry, I can’t really answer that.
When you posted your setups as a pdf file under setup we could download the file and view in a pdf reader, now that you started to post them on your main page, it’s just an image. Was wondering if you could still post the pdf file as well. I carry these PDFs on my iPhone and iPad along with my setup sheets for reference. They are extremely handy.
I will post them in PDF again
Thanks!!
Hey there, noticed your running A & B inserts on the aluminum rear hangers, do you use these inserts on most med/high bite tracks these days and are they ran in or out??? Ive been running D in D in and thinking I ahould probably switch? Thoughts? Nany thanks
Yeah I normally run B in in front and A.
Hi, I have trouble with rear drive shaft in my ZX6, where are losing the pin from the shaft…do you know how to fix it? Thanks, Honza
Hi Jared,
I have just finished to build and paint my zx6
Just by curiosity and in the way to quote a out of the box setup sheet
Have u ever measure the F/R camber and the front toe out angle, out of the box ?
I have tried to measure it by myself but without Tools and only the iPhone it’s not very precise …
Thank you very much one more time 🙂
JTP RC 
Thanks for sharing. Why did you go back to the original chassis vs the new prototype?
RB6 Castor Block Position In(wide Std) is that referring to the hole in making the tire track width wide?
Out(Narrow) hole outside making the tire track width narrow?
Also spacer on front axle (kit show 2mm spacer in and out), typically your setup sheets show 2mm outside only??
Yes, you are correct with the track width. The front axle spacing, I always just run the standard kit spacing.
Jared what was the idea behind putting the front bulkhead under the chassis?
Are you just talking about the design of the RB6? I’m not sure, I did not design it and I’m not an engineer. Sorry, I can’t really answer that.
When you posted your setups as a pdf file under setup we could download the file and view in a pdf reader, now that you started to post them on your main page, it’s just an image. Was wondering if you could still post the pdf file as well. I carry these PDFs on my iPhone and iPad along with my setup sheets for reference. They are extremely handy.
I will post them in PDF again
Thanks!!
Hey there, noticed your running A & B inserts on the aluminum rear hangers, do you use these inserts on most med/high bite tracks these days and are they ran in or out??? Ive been running D in D in and thinking I ahould probably switch? Thoughts? Nany thanks
Yeah I normally run B in in front and A.
Hi, I have trouble with rear drive shaft in my ZX6, where are losing the pin from the shaft…do you know how to fix it? Thanks, Honza
Hi Jared,
I have just finished to build and paint my zx6
Just by curiosity and in the way to quote a out of the box setup sheet
Have u ever measure the F/R camber and the front toe out angle, out of the box ?
I have tried to measure it by myself but without Tools and only the iPhone it’s not very precise …
Thank you very much one more time 🙂